REPRODUCTION. You are purchasing one pair of lower rigid channel runs for the window division bar. This is two pieces, approximately 15 inches in length for each piece. These have a stainless beaded edge, mohair-lining, and are exact replacements for rear side of vent window division bar. Fastens in place by small screws or rivets, drill holes to match your original locations. You are responsible to cut to the exact length required if necessary. Used on the front door and rear door vent window frames for some models, this is for the portion below the door. Please compare to yours to ensure proper fitment.
ATTRIBUTES:
Channel Width: 0.5 Inch (12.7 mm)
Channel Height: 0.5 Inch (12.7 mm)
Length: 15.0 Inches (38.1 cm)
Please check the Matching Vehicles tab to confirm this part is applicable to your vehicle.
